iData 50 - Page 29

iData 50 User Manual
- 27 -
Fault
Cause
Solution
low speed.
the iData 50.
necessary, save the records on the host or
increase the storage capacity by using an
SD card.
Too many applications are
installed on the iData 50.
Remove applications installed on the iData
50.
The iData 50 cannot
decode a barcode while
reading it.
The scan application is not
loaded.
Load the scan application in the iData 50.
Reading a barcode fails.
Check that the barcode is indefective.
The battery volume is low.
If the scanner stops sending out a light
beam after you press the trigger switch,
check the battery volume.