iData 50 - Appendix and Specifications; Accessories of the iData 50

iData 50 User Manual
- 28 -
Table 8-2 Bluetooth troubleshooting
Fault
Cause
Solution
The iData 50 cannot
detect any Bluetooth
device nearby.
The iData 50 system is too
far away from other
Bluetooth devices.
Move the iData 50 close to other Bluetooth
devices, making the distance between them
within 10 meters.
The Bluetooth devices
nearby are not enabled.
Enable the Bluetooth devices you are
searching for.
Bluetooth devices are in a
mode that cannot be
detected.
Set Bluetooth devices in a mode that can be
detected.
When a user attempts to
connect a Bluetooth
phone to the iData 50,
the Bluetooth phone
identifies the iData 50 as
the previously paired
iData 50.
The Bluetooth phone
memorizes the name and
address of the iData 50
paired previously over
Bluetooth.
Remove the paired device and the name
from the Bluetooth phone.
A Bluetooth device can
be detected but cannot
be connected.
The iData 50 does not
support connecting a
Bluetooth device without a
password.
Set a password for the Bluetooth device.
Table 7-3 Cable troubleshooting
Fault
Cause
Solution
Charging fails.
The cable is in poor
contact.
Replace the cable.
Connecting to the iData
50 fails.
The cable is in poor
contact.
Replace the cable.
Table 7-4 Wi-Fi troubleshooting
Fault
Cause
Solution
Connecting to an AP
fails.
The message
“Authentication failed” is
displayed.
The password for the WLAN device is
incorrect.