EN Comfosplit IKARO HW - User and installer manual
© Ideal Clima - Page 56 / 68
CLEANING THE CASING
Clean the unit with a soft and damp cloth. To avoid damaging the unit's finishing does not use abrasive
sponges or detergents.
AIR BLEEDING
Slightly lift the device to disengage from the
couplings of the lower jig, without disengaging it
from the top ones.
Rotate the device, pivoting on the upper hooks
of the template, making sure that it is securely
latched.
With the help of a wedge, keep the unit tilted as
in picture.
The air vent is located as indicated in the figure.
The drain valve is placed on the water return
duct and has a small handwheel, similar to that
of radiators.
Open the vent to let the air contained in the
heat exchanger to escape. Close the vent when
you see only water coming out.
To the handwheel a small duct can be
connected (not supplied), to facilitate the
venting operations.
To Next Page
Loading...