Ideal Clima COMFOSPLIT IKARO - ERROR CODES LIST; ORDINARY MAINTENANCE PROCEDURES

EN Comfosplit IKARO HW - User and installer manual
© Ideal Clima - Page 52 / 68
NR
ANOMALY
ANALYSIS OF THE
CAUSES
CORRECTIVE ACTIONS
Check that the terminals of the actuator
receive 230 V.
Check electrical wiring,
6
Presence of drops of
condensation on the air
supply grid
High humidity
With high room humidity, it is possible that
condensation appears on the grid. These
drops are collected in the drain basin and
are part of normal operation.
8
The remote control does
not operate the device
Battery in remote
control unit might be
discharged
Check if the remote-control display lights
up, if not, replace the batteries.
9
The air flow is weaker
than usual and the
appliance noisier
dirty filters
Clean or, if necessary, replace the filters
17.2 ERROR CODES
The fan coil can show on on-board LCD some error codes when the normal operation is not possible. Such error
codes are:
• E1 = temperature sensor defective
• F4 = possible motor failure.
• E5 = general unit failure
• E0 = general unit failure
In case you see these error codes, try to turn on and off the unit or power supply off and on again, if the error
persists, contact technical support.
17.3 ORDINARY MAINTENANCE
Before any maintenance disconnect the power supply.
Never pour water on the unit.
FILTERRS CLEANING
To ensure an optimal time and quiet unit operation is necessary to clean the filters at least every six months and
replace them every two years.
Proceed as follows:
-Disconnect power supply
Place the main switch in the "off" position.