iDect X1i System - Making and Receiving Calls; Initiating a Phone Call; Answering Incoming Calls; Terminating a Phone Call

Making and answering calls
Using the
speakerphone
The speakerphone lets you hear calls without holding
the handset to your ear.
You can switch between speakerphone and earpiece
mode during calls at any time by pressing the
PHONE/SPEAKERPHONE button. The display will show
SPEAKER PHONE ON or SPEAKER PHONE OFF
To make a call1 Key in the telephone number
If you make a mistake, press the HANG UP
button to clear digits one by one from the display.
2 Press the PHONE button
(You can dial the number after you press the
PHONE button to get Dial tone if you prefer,
but you can’t correct any mistakes if you do it
this way. If you press the PHONE button before
you dial, the display shows
ONLINE.)
To answer a
call
When there’s an incoming call, the base unit and handset
ring (unless the handset’s ringer is turned off). If you
subscribe to Caller Display (see page 20) the caller’s
number or name may appear on the display; otherwise,
the display shows
<<CALL>>.
◗
Press any button (except HANG UP) to answer the
call
è
The display shows ONLINE
To end a call
◗
Press the HANG UP button so that the
IN USE light on the base unit goes out
◗
Or just replace the handset on the base unit
è
The display shows CALL END and the
duration of the call.
14
E:\Binatone2006\iDECT_X1i\iDECT_X1i_UK_03.vp
12 June 2006 10:53:56
Color profile: Generic CMYK printer profile
Composite Default screen