iDect X1i System - Baby Call; To Set or Change the Baby Call Number; To Turn Baby Call on and off

Baby Call With Baby Call (babysitter’s call) turned on, the handset
will automatically dial a specified number when any
button (except MENU) is pressed. Before you can turn
Baby Call on, you must set (programme) the Baby Call
phone number to be dialled.
!
With Baby Call turned on, the iDECT X1i handset
can’t be used for calling Emergency Services. Make
sure there’s an alternative phone available for
emergencies.
To set or
change the
Baby Call
number
1 Select the BABY CALL NUMBER option by
pressing the PHONE/OK button
è
The display shows ENTER BABY NUMBER *
2 Key in the phone number then press the
PHONE/OK button
è
The display goes back to standby mode.
To turn Baby
Call on and off
1 Select the BABY MODE option by pressing the
PHONE/OK button
è
The display shows SET BABY MODE and ON
or OFF
2 Use the â or á button to go to the option
you prefer, then press the PHONE/OK
button to confirm
è
The display goes back to standby mode,
with
BABY MODE shown on the middle line.
If you try to turn Baby Call on before you’ve set
a Baby Call number, the display will show
ENTER BABY NUMBER * and you’ll need to key a
number in.
Your handset’s
name
See page 9.
Handset settings
E:\Binatone2006\iDECT_X1i\iDECT_X1i_UK_03.vp
12 June 2006 10:54:05
Color profile: Generic CMYK printer profile
Composite Default screen
50