Identix rPad - Inventory Gen2 Session and Cycle Settings; Gen2 Session Configuration; Tag Population Estimate; Inventory Cycle Settings

MiniPad – rPad User Guide
16
© 2015-2017 – Identix Inc. All Rights Reserved.
Behavior of Search Mode and Sessions on intermittent reading field
Inventory Gen2 Session
Session= X set the session under Gen2 standard for Tag inventory. Chose session: 0, 1, 2 or
3.
Tag Population Estimate
TagPopulationEstimate= 4 an estimate of the tag population in view of the RF field of the
antenna
• Defines the estimation of the tag population you want to read
• This parameter is used to optimize the anti-collision algorithm
• Set this value to a power of 2
Inventory Cycle
InventoryCycle=0,0 sets the inventory cycle duration and interval (on-off) in milliseconds. Set
to 0,0 (default) for continuous inventory
• Users can define the inventory cycle (on/off) interval. For instance, to read tags for a period
of 5 seconds and sleep another 5 seconds, set InventoryCycle=5000,5000
A B
A B
A B
A B
A B
TS1
TS1
A B A B A
B
time
TS1
A B A B A B A B A B A B A BA
A
A
A B A B A B A B A B
A B A B
A B
…
>5s
Dual Target
session x
Single Target
Session 1
Single Target
Session 2 or 3
Single Target
with Suppression
Tag on reader field (energized)
Tag out of reader field
(not energized)
Tag on reader field (energized)