Need help?Do you have a question about the Identix rPad and is the answer not in the manual?
General| Brand | Identix |
|---|---|
| Model | rPad |
| Category | Rfid Systems |
| Language | English |
Instructions and links for downloading necessary software and drivers.
Step-by-step guide for installing the USB driver on Windows.
Device controlled by host application via IRI protocol over virtual COM port.
Device emulates a keyboard wedge, sending tag data as keyboard input.
Host application controls device using simple ASCII commands over virtual COM.
Method to switch between Transparent, HID, and RAW modes using a config file.
Steps to read RFID tags when the device is in Transparent Mode.
Steps to read RFID tags when the device is in HID Keyboard Emulation Mode.
Steps to read RFID tags when the device is in RAW Mode.
Guide to download and configure the PuTTY terminal emulator.
How to establish a serial connection and interact via commands.
Explains the 'Opmode' setting for device operation modes (T, H, R).
Explains the 'Region' setting for country-specific frequency compliance.
Explains the 'TXPower' setting for transmitter power in dBm.
Describes the 'D' mode for dual target inventory searches.
Describes the 'S' mode for single target inventory searches.
Describes the 'SS' mode for single target searches with suppression.
Explains setting the Gen2 inventory session (0, 1, 2, or 3).
Explains 'TagPopulationEstimate' for optimizing anti-collision.
Explains 'InventoryCycle' for setting inventory duration and interval.
Explains filtering tags based on Received Signal Strength Indication (RSSI).
Configures automatic decoding of SGTIN96 EPC data into human-readable format.
Configures the inclusion of Tag Unique ID (TID) data in reports.
Configures the inclusion of RSSI values in inventory reports.
Instructions for editing the configuration file with Notepad in HID mode.
Editing the config file for RAW mode (requires reboot).
Using PuTTY to change parameters without rebooting the device.
Command to include RSSI data in inventory reports.
Command to view the current configuration settings.
Simplest integration method, acting as a barcode scanner.
Options for integrating via RAW mode or IRI API.
Using ASCII commands over serial for integration.
Using Impinj Reader Interface for full feature integration.
How to find device info from the IdevInfo.txt file.
Locating the IdevInfo.txt file to check the current controller firmware.
Modifying Identix-Pad.cfg to enable DFU mode for firmware update.
Using the Python_Firmware_UpgradeGUI.exe utility.
Choosing the firmware file and initiating the programming process.
Steps to reconnect the device after the update.
Checking the updated firmware version via Idevinfo.txt.
Checking the RFID SIP firmware version using IdevInfo.txt.
Setting the device to Transparent Mode for RFID SIP update.
Launching the tool and detecting the connected MiniPad/rPad.
Choosing the firmware file and initiating the load process.
Using the 'Set/Get' tab to retrieve updated device information.
Verifying the RFID SIP firmware version via the Idevinfo.txt file.
Using RecoverIRIdevice=True in config file for emergency reset.
Displays antenna gain patterns for MiniPad and rPad devices.
Compliance information regarding FCC regulations and potential interference.
Legal notices, copyright, disclaimers, and warranty information.
Lists Identix trademarks and other product/service names.
To Next Page