IDS400 USER MANUAL NO. 700-204-01A ISSUED NOV 2000 VER 1.01 13
IDS400 USER MANUAL
2. If necessary, close the front door.
3. Press the [#] key to cancel any unintended entries.
4. Enter a valid [USER CODE].
5. DO NOT open the front door. If the front door is opened the
system will arm in AWAY mode.
6. The ARMED indicator will illuminate and the audible indicator
will sound on and off for the duration of the exit delay.
7. The AWAY indicator will remain extinguished.
8. Any STAY zones (shown by a steadily illuminated indicator) will
be automatically bypassed.
9. Ensure that you enter only those zones that are bypassed.
5.4 Quick Stay Arming
[5] - Hold down the key until the keypad audible indicator sounds.
It is possible to STAY arm by holding down the [5] key until the
keypad beeps. If the system is armed using the quick STAY arm key,
there is no exit delay.
5.5 Stay Arm and Go
[6] - Hold down the key until the keypad audible indicator sounds.
This is a quick function which allows the user to STAY arm and leave
the premises. This is useful if you have a guest or a pet moving around
on the property.
1. Hold down the [6] key until the audible indicator sounds.
2. The ARMED indicator will illuminate and the AWAY indicator will
remain extinguished. Any stay zones will be bypassed.
3. Be sure to leave only via the follower and entry/exit zones.
5.6 Arming from a Key-Switch or Remote Control
This option is not standard; check with your installer to verify
installation.
1. Ensure that the READY indicator is illuminated before leaving.
2. Leave and close the door (remembering to lock!).
3. Press the remote button or twist and release the key-switch.
To Next Page
Loading...
Need help?
General
