IDS400 USER MANUAL NO. 700-204-01A ISSUED NOV 2000 VER 1.01 15
IDS400 USER MANUAL
6.2 To Un-Bypass Zone
[-] + [ZONE NUMBER]
1. Press the [-] key.
2. Press the number corresponding to the currently bypassed zone
3. The zone indicator will extinguish - the zone is now active.
7. Disarming the System
[#] + [USER CODE]
To disarm the system, enter a valid [USER CODE] before the expiry of
the entry delay. Although not essential, it is recommended that the [#]
key be pressed before entering a user code as this clears any
unintended key entries.
L Enter the premises through a designated entry/exit door; enter-
ing by any other door will sound an immediate alarm.
L As soon as the entry/exit zone is violated i.e. the door has been
opened, the entry delay begins.
L The audible indicator will sound for the duration of the entry
period to indicate that a valid user code is required.
L If the ARMED indicator remains illuminated, an error was made
while entering the user code, press the [#] key and re-enter the
code.
L Once the system disarms, the ARMED indicator will extinguish
and the audible indicator will stop sounding.
L If no valid user code has been entered by the end of the entry
delay period, an alarm condition will be registered.
L If the entry period is too short, have your installer change the
entry delay period.
NOTE:
If the ARMED indicator is flashing upon entry, there has been a
violation. The intruder may still be inside! Call for assistance.
NOTE:
Enter a valid [USER CODE] to cancel the strobe (Where one has been
installed.
To Next Page
Loading...
Need help?
General
