20 IDS400 USER MANUAL NO. 700-204-01A ISSUED NOV 2000 VER 1.01
IDS400 USER MANUAL
12.2 To Cancel the Stay Zones
Summary: [3] + [-] + [ZONE NUMBER] + [#]
If an area programmed as a STAY zone will no longer be violated
during STAY arming, then the STAY status of such a zone should be
cancelled. This will allow the system to protect that area during a stay
arm cycle.
1. Ensure that the READY indicator is illuminated.
2. Hold down the [3] key until the audible indicator sounds.
3. Press the [-] key followed by the [NUMBER] corresponding to
the STAY zone you wish to cancel.
4. The relevant zone indicator will extinguish.
5. Press the [#] key to exit the stay zone programming mode.
NOTE:
The system will automatically exit this mode after 60 seconds.
13. Chime Zones
The chime mode allows the user to monitor nominated zones while the
system is disarmed. The audible indicator will sound briefly when the
nominated zone is violated - the siren will NOT sound.
EXAMPLE:
You wish to know when someone enters or exits the front door, the
keypad will beep each time the door is opened if that zone is a chime
zone.
13.1 To Program the Chime Zones
Summary: [2] + [-] + [ZONE NUMBER] + [#]
1. Hold down the [2] key until the audible indicator sounds.
2. The AWAY indicator will flash to show that the panel is on the
chime programming mode.
3. To monitor any zone, press the key corresponding to that zone.
The zone indicator will illuminate.
4. Repeat steps 1 - 3 to program any other zones to the chime
To Next Page
Loading...
Need help?
General
