IDS400 USER MANUAL NO. 700-204-01A ISSUED NOV 2000 VER 1.01 7
IDS400 USER MANUAL
Glossary
Alarm This is the history of the most recent violations that
Memory occurred the last time the system was armed.
Arm To set the system into the ARMED mode. In this mode,
violating a zone will activate an alarm condition and, if the
system is programmed accordingly, will cause a reporting
code to be sent to the monitoring company.
Bypass To deactivate a zone, so that it will not respond if
violated. When the panel is ARMED, violation of a by-
passed zone will be ignored.
Disarm To take the system out of the armed mode. In this mode,
only a violation of a PANIC zone will activate an alarm
condition. Fire and Medical functions remain active.
Entry/ Exit A zone with a programmable time delay, that allows the
Zone user to exit the premises after arming the system and
time to get to the keypad after entering the armed
premises.
Follower A zone that may be temporarily violated - only after an
Zone entry/exit zone is violated. This allows the user access to
disarm the system. A Follower zone will behave as per
an Instant zone if violated prior to the violation of an entry/
exit zone.
Instant When the system is armed, a violation of an instant zone
Zone will immediately cause an alarm condition to be
registered.
Stay Arm Arming that allows for certain preprogrammed, STAY
or bypassed zones to be violated while the system is
armed.
Stay Arm Arming that allows the user to stay arm and leave the
and Go premises.
Stay Zone Zones which are bypassed automatically when the
system is STAY ARMED.
Zone A specific area of your premises guarded by sensors
which detect violations of that area.
To Next Page
Loading...
Need help?
General
