Need help?Do you have a question about the IDTECK iTDC EIO8 and is the answer not in the manual?
General| Brand | IDTECK |
|---|---|
| Model | iTDC EIO8 |
| Category | IP Access Controllers |
| Language | English |
Describes the installation layout for controlling two doors using iTDC/iTDC-SR.
Describes the installation layout for controlling three doors using iTDC/iTDC-SR with EIO88.
Describes the installation layout for controlling four doors using iTDC/iTDC-SR with EIO88.
Identifies the wiring parts and terminal blocks on the iTDC/iTDC-SR board.
Identifies the wiring parts and terminal blocks on the EIO88 board.
Explains how to set the unique Board ID for serial communication using DIP switches.
Details the importance and procedure for connecting the Earth Ground wire for safety.
Guides on connecting the DC12V power supply to the iTDC/iTDC-SR board.
Explains how to connect multiple devices using RS422 communication via a converter.
Details recommended cables, GND connection, and termination resistors for RS422.
Describes connecting multiple iTDCs via TCP/IP module for RS422 communication.
Provides guidance on recommended cables, GND connection, and termination resistors for TCP/IP.
Explains how to install and configure the TCP/IP module for network communication.
Details network information settings (IP, Subnet, Gateway, Port) for the TCP/IP module.
Covers serial communication settings and optional parameters for the TCP/IP module.
Details the wiring connections for RF readers to the iTDC/iTDC-SR.
Guides on connecting door contacts and exit buttons to the input port terminal blocks.
Explains the importance of connecting Earth GND to metal frames for input devices.
Details wiring for a 'Power Fail Safe' door lock, including diode connection.
Details wiring for a 'Power Fail Secure' door lock, including diode connection.
Explains wiring for 24V door locks and automatic doors using external relays.
Details wiring for connecting an alarm device, including diode connection.
Describes how to configure input/output ports for 2, 3, or 4 doors, including EIO88 attachment.
Guides on how to perform system initialization to restore default factory settings.
To Next Page
