Need help?Do you have a question about the IDTECK iTDC-SR and is the answer not in the manual?
Crucial instructions to prevent hazards and ensure safe operation of the device.
How to configure the device based on the communication method (RS232, RS422, TCP/IP).
Explanation of the various ports on the main board and their wiring purposes.
Step-by-step guide for the fundamental installation process of the iTDC/iTDC-SR device.
How to set the unique communication ID for each device on the network.
Procedures for connecting the device to earth ground for safety and surge protection.
How to perform an initial system setup to restore factory default settings.
Step-by-step process for registering new user IDs (card data) into the system.
Steps to diagnose and resolve issues where the device fails to communicate with the PC.
Troubleshooting steps for when the device fails to respond or reads incorrect card numbers.
Steps to resolve issues where registered cards are not authenticated by the system.
General| Model | iTDC-SR |
|---|---|
| Type | IP Access Controller |
| Card Capacity | 50, 000 |
| Log Capacity | 100, 000 |
| Reader Port | 2 |
| Input Ports | 4 |
| Tamper Switch | Yes |
| CPU | 32-bit RISC |
| Memory | 8MB Flash |
| Communication Protocol | TCP/IP |
| Communication | Ethernet |
| Reader Type | Wiegand |
| Wiegand | 26bit, 34bit |
| Reader Interface | Wiegand, RS-485 |
| Output Ports | 4 |
| Power Supply | 12VDC |
| Operating Humidity | 10% to 90% RH |
| Humidity | 10% to 90% RH |
To Next Page
