IFT Evolve 300 CX - Flight Controls and Trimming

17



IntheeventyouarenotfamiliarwiththecontrolsoftheEvolve300CXpleasetakethetime
tofamiliarizeyourselfwiththemasfollowsandbeforeproceedingwithyourfirstflight:

Theleft‐handstickonthetransmittercontrolsboththethrottle(climb/descend)andrudder
(yawleft/right)channels.Whentheleft‐handstick(alsoknownasthe‘throttle’stick)isinthe
lowestpossiblepositiontherotorbladeswillnotspin.Movingthestickupwardwillincrease
thespeed/RPMsoftherotor
blades.Increasingthespeed/RPMsoftherotorbladeswillcause
themodeltoclimb.



Decreasingthespeed/RPMsoftherotorbladesbyloweringtheleft‐handstickwillcausethe
modeltodescend.



Afterliftingthehelicopteroffthegroundyoucanmaintainaltitudein‘hover’bycarefully
movingtheleft‐handstickupanddownslightlyasneededsothehelicopterwillnotclimbor
descend.
Fli
g
ht Controls and Trimmin
g