To Next Page

To Previous Page

English

5.2.3 Enable/disable touch knob features

iRig Keys I/O touch sensitive knobs allows you to see the current value setted on each knob by touch it. Also,

each touch can send a CC freely assignable. It is possible to enable/disable these features:

• Enter Edit Mode by pressing the ALT and EDIT buttons;

• The display will show GLO. Press the DATA push-knob to confirm you want to edit a parameter in the global

menu;

• By rotating the DATA knob you will cycle between the parameters of the Global menu;

• Reached the TCH position pess the DATA push-knob to confirm you want to enable/disable the touch

feature;

• The display will show CC and will cycle between CC and SNS. The CC (control change) allows you to

enable or disable the sending of the CC message associated to the touch of each knob; the SNS (sensing)

allows you to enable or disable the capacite sensitive feature of the knobs. These are the possible

combinations: CC (OFF) and SNS (ON), default -> the CC assigned to the touch of the knob is OFF; CC

(ON) and SNS (OFF) -> the CC assigned to the touch of the knob is sent when you start rotating the knob

and not when the knob is just touched;

• If you select, for example, CC:

• By rotating the DATA knob clockwise you’ll turn ON the feature; turning counter-clockwise the DATA knob

you’ll turn it OFF. By default this feature is set to OFF;

• If you select, for example, SNS:

• By rotating the DATA knob clockwise you’ll turn ON the feature; turning counter-clockwise the DATA knob

you’ll turn it OFF.

• To confirm your input press the DATA push-knob;

• The keyboard will exit automatically the Edit Mode;

• You can exit the Edit mode any time by pressing the CANCEL/NO key.

IK Multimedia iRig Keys I/O User Manual

Questions and Answers: