To Next Page

To Previous Page

English

• Enter Edit Mode by pressing the ALT and EDIT buttons;

• The display will show GLO. Rotate the DATA knob until you reach the PRE position. Press the DATA push-

knob to confirm you want to edit a parameter in the preset menu;

• The display will show DTA. Rotate the the DATA knob clockwise to reach the PED position;

• Reached the PED position press the DATA push-knob;

• The display will show EXP and will cycle to EXP (expression) to SUS (sustain) turning the DATA knob. Press

the DATA push knob to confirm you want to edit the message sent by the Sustain pedal;

• The display will show CC. Press the DATA push-knob to confirm you want to assign a CC to the Sustain

pedal;

• The display will show NBR (number) to let you insert the CC number you want to assign to the knob;

• Insert the MIDI control change number (from 0 to 127) with the keys marked from 0 to 9. You can cancel

your input with the CANCEL/NO key;

• To confirm press the DATA push-knob;

• The display will show MOM (momentary) or LCH (latch) to let you set the way the pedal will send the

message. To confirm press the DATA push-knob;

• The keyboard will exit automatically the Edit Mode;

• You can exit the Edit mode any time by pressing the CANCEL/NO key.

5.3.3.3 Assign PC to the Sustain pedal

• Enter Edit Mode by pressing the ALT and EDIT buttons;

• The display will show GLO. Rotate the DATA knob until you reach the PRE position. Press the DATA push-

knob to confirm you want to edit a parameter in the preset menu;

• The display will show DTA. Rotate the the DATA knob clockwise to reach the PED position;

• Reached the PED position press the DATA push-knob;

• The display will show EXP and will cycle to EXP (expression) to SUS (sustain) turning the DATA knob. Press

the DATA push knob to confirm you want to edit the message sent by the Sustain pedal;

• The display will show CC and will cycle between CC and PC turning the DATA knob. Reached the PC

position press the DATA push-knob to confirm you want to assign a PC to the Sustain pedal;

• The display will show NBR (number) to let you insert the CC number you want to assign to the knob;

IK Multimedia iRig Keys I/O User Manual

Questions and Answers: