English
21
10.1 EDIT scene global parameters
10.1.1 EDIT Global transmit MIDI Channel
To edit the scene transmit MIDI channel:
• Enter EDIT mode.
• Press pad 14 (MIDI CH).
• All pads between 1 and 9 will light up GREEN.
• Compose the MIDI CH number using the 1-10 pads (10 means 0). At each press the pads will flash RED. In
case a wrong value is inserted, EDIT pushbuttons will flash.
• Press pad 16 (ENTER) to confirm the selection.
10.1.2 Set pads velocity sensitivity
To set pad velocity sensitivity:
• Enter EDIT mode.
• Press pad 1 to set a soft, compressed velocity sensitivity.
• Press pad 2 to set a normal velocity sensitivity.
• Press pad 3 to set a hard, expanded, velocity sensitivity.
• The selected pad will flash red to confirm the selection.
• Press pad 16 (ENTER) to confirm the selection.
10.1.3 Shift octaves for pads notes
To shift octaves for pads notes:
• Enter EDIT mode.
• Press pad 11 to shift down by one octave. The pad will flash a number of times equal to the number of
octaves that have been shifted.
• Press pad 12 to shift up by one octave. The pad will flash a number of times equal to the number of octaves
that have been shifted.
• When there is an active shift up or down the corresponding pad will illuminate ORANGE (instead of the edit-
default GREEN).
• Press pad 16 (ENTER) to confirm the selection.
To Next Page
Loading...
Need help?
General
