English
25
10.2.8 Assign CC to Rotary Knobs
To assign a CC message to a Rotary Knob:
• Enter EDIT mode.
• Rotate the Rotary Knob you want to associate the CC to.
• Pads 4, 10 and 14 will illuminate RED.
• Press pad 4 if you want to assign the selected rotary knob a pitch bend control.
• Press pad 10 to assign a CC.
• Compose the MIDI CC number using the 1-10 pads (10 means 0). At each press the pads will flash RED. In
case a wrong value is inserted EDIT pushbuttons will flash.
• When done press pad 16 (ENTER) to confirm the selection and exit the EDIT mode.
10.2.9 Assign MIDI CH to Rotary Knobs
To assign a MIDI CH to a Rotary Knob:
• Enter EDIT mode.
• Rotate the Rotary Knob you want to associate the MIDI CH to.
• Pads 4, 10 and 14 will illuminate.
• Press pad 14 (MIDI CH).
• All pads between 1 and 9 will light up GREEN.
• Compose the MIDI CH number using the 1-10 pads (10 means 0). At each press the pads will flash RED. In
case a wrong value is inserted EDIT pushbuttons will flash.
• Press pad 16 (ENTER) to confirm the selection and exit the EDIT mode.
10.2.10 Assign CC to the Slider
To assign a CC message to the Slider:
• Enter EDIT mode.
• Move the Slider.
• Pads 4, 10 and 14 will illuminate RED.
• Press pad 4 if you want to assign to the slider a pitch bend control.
• Press pad 10 to assign a CC.
• Compose the MIDI CC number using the 1-10 pads (10 means 0). At each press the pad will flash RED. In
case a wrong value is inserted EDIT pushbuttons will flash.
• When done press pad 16 (ENTER) to confirm the selection and exit the EDIT mode.
To Next Page
Loading...
Need help?
General
