English
26
10.2.11 Assign MIDI CH to the Slider
To assign a MIDI CH to the Slider:
• Enter EDIT mode.
• Move the Slider.
• Pads 4, 10 and 14 will illuminate.
• Press pad 14 (MIDI CH).
• All pads between 1 and 9 will light up GREEN.
• Compose the MIDI CH number using the 1-10 pads (10 means 0). At each press the pads will flash RED. In
case a wrong value is inserted EDIT pushbuttons will flash.
• Press pad 16 (ENTER) to confirm the selection and exit the EDIT mode.
10.2.12 Assign CC to the DATA Knob
To assign a CC message to the DATA knob:
• Enter EDIT mode.
• Move the DATA knob.
• Pads 10, 14 and 15 will illuminate RED.
• Press pad 10 to assign a CC.
• Pads 7 and 8 will illuminate RED.
• Press pad 7 (ABS) if you want the DATA knob to work in Absolute mode sending CC values from 0 to 127
when rotated CW and from 127 to 0 when rotated CCW.
• Press pad 8 (REL) if you want the DATA knob to work in Relative mode (to control list of elements) sending
CC values from 0 to 10 (depending on the rotation speed) when moved CW and from 127 to 117 (depending
on speed) when moved CCW.
• Compose the MIDI CC number using the 1-10 pads (10 means 0). At each press the pad will flash RED. In
case a wrong value is inserted EDIT pushbuttons will flash.
• When done press pad 16 (ENTER) to confirm the selection and exit the EDIT mode.
10.2.13 Assign PC to the DATA Knob
To assign a PC message to the DATA knob:
• Enter EDIT mode.
• Move the DATA knob.
• Pads 10, 14 and 15 will illuminate RED.
• Press pad 15 (PC).
• Compose the MIDI PC number using the 1-10 pads (10 means 0). At each press the pad will flash RED. In
case a wrong value is inserted EDIT pushbuttons will flash.
• When done press pad 16 (ENTER) to confirm the selection and exit the EDIT mode.
To Next Page
Loading...
Need help?
General
