English
27
10.2.14 Assign MIDI CH to the DATA Knob
To assign a MIDI CH to the DATA Knob:
• Enter EDIT mode.
• Move the DATA knob.
• Pads 10, 14 and 15 will illuminate.
• Press pad 14 (MIDI CH).
• All pads between 1 and 9 will light up GREEN.
• Compose the MIDI CH number using the 1-10 pads (10 means 0). At each press the pads will flash RED. In
case a wrong value is inserted EDIT pushbuttons will flash.
• Press pad 16 (ENTER) to confirm the selection and exit the EDIT mode.
10.2.15 Assign CC to the DATA Pushbutton
To assign a CC message to the DATA pushbutton:
• Enter EDIT mode.
• Press the DATA pushbutton.
• Pad 9, 10, 14 and 15 will illuminate RED.
• Press pad 10 to assign a CC.
• Pads 5 (temp) and 6 (toggle) will illuminate RED.
• Press pad 5 or 6 depending if you want the note behavior to be temporary (temp) or latched (toggle).
Selected mode will quickly flash to confirm the selection.
• Compose the MIDI CC number using the 1-10 pads (10 means 0). At each press the pad will flash RED. In
case a wrong value is inserted EDIT pushbuttons will flash.
• When done press pad 16 (ENTER) to confirm the selection and exit the EDIT mode.
10.2.16 Assign PC to the DATA Pushbutton
To assign a PC message to the DATA pushbutton:
• Enter EDIT mode.
• Press the DATA pushbutton.
• Pads 9, 10, 14 and 15 will illuminate RED.
• Press pad 15 to assign a PC.
• Compose the MIDI PC number using the 1-10 pads (10 means 0). At each press the pad will flash RED. In
case a wrong value is inserted EDIT pushbuttons will flash.
• When done press pad 16 (ENTER) to confirm the selection and exit the EDIT mode.
To Next Page
Loading...
Need help?
General
