illy IPERESPRESSO X7.1 - Heating Water; Coffee After Steam Wand Use

33
EN
TO HEAT WATER
The steam wand which comes with the machine also dispenses hot water to make teas and infusions.
Make sure the brew button is lit.
Proceed as follows:
1
Clean any milk residue from the
steam wand.
2
Place a metal jug under the
steam wand.
3
Press and hold the steam but-
ton for at least 3 seconds.
The wand starts to dispense hot
water and the steam button
ashes rapidly.
Press the steam button
again to stop the wand from
dispensing hot water.
MAKING COFFEE AFTER USING THE STEAM WAND
Never make an espresso immediately after using the steam wand, as the water passing through the thermoblock is too hot for making coee and will compromise its avour.
The brew button is disabled when the temperature of the thermoblock is too high.
1
To return to coee-maker
mode, press the brew button
and wait for the coee cup
symbol to light up ; during
the cooling phase (about 10
minutes), the large coee cup
symbol ashes.
2
To return the machine to cof-
fee-maker mode more quickly
(about 1 minute), proceed as
follows:
• Place a metal jug under the
steam wand.
3
• Press and hold the steam but-
ton for 3 seconds.
The steam wand dispenses the
programmed amount of hot
water; the dispenser shuts o
automatically.