illy IPERESPRESSO X7.1 - Descaling Procedure

34
EN
DESCALING
1. If the warning symbol on the outer dial starts ashing (once every 2 seconds), you need to descale your machine. This is a two-step process: rst, descaling (approx. duration 14
minutes), followed by rinsing (approx. duration 3 minutes).
2. Limescale accumulation is a normal result of machine use. The machine has an automatic program that helps optimize cleaning and removes scale deposits from the interior. Failure
to descale your machine may result in malfunctions that are not covered by the warranty.
3. For the descaling procedure, refer to that indicated in the corresponding chapter in this manual. Use only descaling products for coee machines, dissolved according to the proce-
dures indicated in the instructions for the product.
4. In the event of a power outage during the descaling procedure, the descaling cycle resumes at the point it was interrupted.
1 2 3 4
1 L
5
Switch the machine o. • Remove the water tank and ll it with 1 litre of water (up to the
MAX line). Remove the capsule holder.
• Pour the descaling solution into the tankand mix until fully dis-
solved.
• Remove the tip from the steam wand to make the next operation
easier.
• Place a recipient of capacity of at least 1litre under the dispenser
head and steam wand.
6
Switch the machine on: within 15 seconds of switching on, press
and hold the button until the machine emits 4 beeps (3 short
and 1 long). Release the button.
The
button ashes: the machine is ready to start the
descaling cycle.
7
Press once and release the button to start the descaling cycle.
Buttons and ash alternately. The machine's dispenser
head and steam wand will intermittently emit water while the
operation is in progress (duration: 14 minutes).
NOTE: the descaling cycle can be put on hold by pressing
the
button. Press the button to resume the cycle.