illy IPERESPRESSO X7.1 - Troubleshooting Guide

38
EN
TROUBLESHOOTING
PROBLEM SOLUTION
The button does not light up when pressed.
Check the mains power connection; check the mains switch on your fuseboard.
The machine does not brew coee.
Proceed as follows:
- Fill the water tank; return it to its place, making sure it is properly inserted.
- Remove the capsule holder from the dispenser head.
- Wait for the
button to light up (machine ready to brew).
- Place a recipient under the dispenser head and press the coee dispenser button.
- Allow the machine to dispense water for a few seconds.
- Interrupt the operation
- Insert a new capsule in the capsule holder and click it into place in the dispenser head; dispense coee as shown in the instructions.
The machine does not dispense steam when the
button is pressed. Steam comes out but the
milk is not foamy.
Scenario a) If the steam symbol on the outer dial is lit, wait for the steam button to light up.
Scenario b) If the steam symbol on the outer dial is not lit, press the steam button and wait for this button to light up (reheat).
Scenario c)
Possible obstruction of dispenser: switch the machine o; allow it to cool down (at least one hour); remove obstructions from the
outlet holes in the steam wand.
Water leaks from the dispenser head during use Insert a new capsule in the capsule holder; twist the handle to click it into position and proceed to brew coee as shown in the instructions.
Short, repeated beeps and ashing triangle
symbol
Proceed as follows:
- Switch the machine o.
Fill the water tank.
- Place a recipient under the steam wand and press the
button.
- Switch on the machine and wait about 10 seconds for the button to light up.
Triangle symbol
ashing rapidly
Descale the machine
Water leaks from inside the machine Switch o the machine and remove the plug from the power socket.
Water leaks from the water tank after lling Empty the tank and apply pressure to the transparent rubber washer in the intake valve inside the tank.
Drops of coee overow from the capsule when
the machine starts brewing
Minor dripping during the rst couple of seconds of brewing is normal.
If the problem persists, contact an authorized service centre.