COMMAND REFERENCE
Command Reference
7/01 LDC-3700 Series 89
CHAPTER 4
Action Recalls a stored setup configuration from memory.
Value range 0 through 10
Notes Setup 0 has a factory−set default configuration.
If you use GPIB to recall setup 0 (*RCL 0), GPIB mode is set to REMOTE. If you recall setup "0" by
the front panel, GPIB mode is set to LOCAL.
Same function as RECALL on the front panel.
Use *SAV to store various setup configurations for convenient recall.
The current setup is automatically stored and recalled at next power−ON, unless you use *PSC to
tell the instrument not to do so.
Examples *RCL 0 Recall the factory default setup.
Action Performs a device reset and the following:
Sets OCIS state
Sets OQIS state
Notes OCIS = Operation−complete Command Idle State. This is the same state as after *OPC: no further
operations to complete.
OQIS = Operation−complete Query Idle State. This is the same state as after *OPC?: no further
operations to complete.
These idle states allow the 8033 to complete its reset process (no operations pending) before con−
tinuing with other operations.
Example *RST
Action Saves the current setup configuration in memory.
Value range 1 through 10
Notes Configuration 0 is reserved for a factory−set default configuration. See *RCL.
It is normally not necessary to save the current setup for next power−ON. The current setup is
automatically stored for recall at next power−ON unless you use *PSC not to do so.
Example *SAV 2—Save the current setup configuration as #2.
*RCL <nrf value>
Recall
COMMON
DEVICE DEPENDENT
FRONT PANEL
*RST
Reset
COMMON
DEVICE DEPENDENT
FRONT PANEL
*SAV <nrf value>
Save
COMMON
DEVICE DEPENDENT
FRONT PANEL
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
