ILX Lightwave LDC-3700B Series - Page 105

COMMAND REFERENCE
Command Reference
90 LDC-3700 Series
CHAPTER 4

Action Enables bits in the service request enable register.
Notes Response is the sum of the enabled bits.
Example *SRE 136 Enable the service request enable register condition summary and error message
bits (8 + 128 = 136).
Action Requests the value in the service request enable register.
Notes Response is the sum of the enabled bits.
See Chapter Three for more information about register structure.
Example *SRE? Response 136 means the service request enable register condition summary and
error message bits are enabled (8 + 128 = 136).
Action Requests the value in the status byte register.
Notes Response is the sum of the enabled bits.
See Chapter Three for more information about register structure.
Example *STB?˙Response 200 means the status byte condition and master status summary bits, and error
message bits, are enabled. (8 + 64 + 128 = 200)
The TEC:CAL:CONST? query returns a stored calibration value. It is intended for factory use only.
*SRE <nrf value>
Service Request Enable
COMMON
DEVICE DEPENDENT
FRONT PANEL
*SRE?
Service Request Enabled?
COMMON
DEVICE DEPENDENT
FRONT PANEL
*STB?
Status Byte?
COMMON
DEVICE DEPENDENT
FRONT PANEL
TEC:CAL:CONST?
COMMON
DEVICE DEPENDENT
FRONT PANEL
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com