COMMAND REFERENCE
GPIB Command Reference Summary
7/01 LDC-3700 Series 57
CHAPTER 4
TEC:CAL:ITE? NONE Returns the ready state for entering a TE current source
calibration value.
TEC:CAL:SEN 1 Used to enter the sensor calibration mode.
TEC:CAL:SEN? NONE Returns the ready state for entering a sensor calibration value.
TEC:CAL:V 1 Used to enter the TEC voltage calibration mode.
TEC:CAL:V? NONE Returns the ready state for entering a TEC voltage calibration
value.
TEC:CONST 1 − 3 Used to enter temperature sensor constants, C1, C2, and C3
TEC:CONST? NONE Used to read back the temperature sensor constant values.
TEC:DIS 1 Turns the TEC display on or off.
TEC:DIS? NONE Returns the TEC display value, on/off.
TEC:DIS:ITE NONE Turn on/off TEC display to show TEC current.
TEC:DIS:ITE? NONE Returns status of TE current display, on/off.
TEC:DIS:R NONE Turn on/off display to show the temperature sensor value, V, I, or
R.
TEC:DIS:R? NONE Returns status of sensor value display, on/off.
TEC:DIS:SET NONE Shows the TEC display set point corresponding to TEC mode
TEC:DIS:SET? NONE Returns status of TEC set point display, on/off.
TEC:DIS:T NONE Turns on/off TEC display to show temperature.
TEC:DIS:T? NONE Returns status of temperature display, on/off.
TEC:ENAB:COND 1 Sets the enable register for TEC conditions.
TEC:ENAB:COND? NONE Returns the value of the TEC conditions enable register.
TEC:ENAB:EVE 1 Sets the enable register for TEC events.
TEC:ENAB:EVE? NONE Returns the value of the TEC event enable register.
TEC:ENAB:OUTOFF 1 Sets the enable register for TEC conditions which turn the TEC
output off.
TEC:ENAB:OUTOFF? NONE Returns the value of the TEC outoff enable register.
TEC:EVENT? NONE Returns the value of the TEC event register.
TEC:GAIN 1 Used to set TEC control loop gain parameter.
TEC:GAIN? NONE Used to return the TEC control loop gain parameter.
TEC:ITE 1 Used to set the TEC current (ITE) set point.
TEC:ITE? NONE Returns the measured TEC current (ITE) value.
TEC:LIM:ITE 1 Used to set the TEC constant current source limit value.
TEC:LIM:ITE? NONE Used to return the TEC constant current source limit value.
TEC:LIM:THI 1 Used to set the TEC upper temperature limit value.
TEC:LIM:THI? NONE Returns the TEC upper temperature limit value.
TEC:MODE? NONE Returns the mode, ITE (TEC current), R (sensor) or T
(temperature).
TEC:MODE:ITE NONE Sets the mode to constant TEC current mode.
TEC:MODE:R NONE Sets the mode to constant thermistor resistance/linear sensor
reference mode.
TEC:MODE:T NONE Sets the TEC mode to constant temperature mode.
Table 4.1 GPIB Command Summary Reference List
Name Parameters Function
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
