ILX Lightwave LDC-3700B Series - Page 73

COMMAND REFERENCE
GPIB Command Reference Summary
58 LDC-3700 Series
CHAPTER 4

TEC:OUT 1 Used to enable/disable the TEC current output.
TEC:OUT? NONE Returns the TEC OUTPUT status.
TEC:R 1 Sets the constant sensor mode, resistance, voltage, or current.
TEC:R? NONE Returns the measured temperature sensor value.
TEC:SEN? NONE Returns the position of the SENSOR SELECT switch.
TEC:SET:ITE? NONE Returns the constant ITE (TEC current) set point.
TEC:SET:R? NONE Returns the constant R (temperature sensor value) set point.
TEC:SET:T? NONE Returns the constant T (temperature) set point.
TEC:T 1 Used to set the TEC constant T (temperature) set point.
TEC:T? NONE Returns the TEC measured temperature value.
TEC:TOL 1 or 2 Used to set the TEC set point tolerance value and time period
value.
TEC:TOL? NONE Used to return the TEC set point tolerance value and time period
value.
TEC:V 1 Used to enter the TEC voltage value during calibration.
TEC:V? NONE Used to return the TEC voltage measurement value.
TERM 1 Used to add a carriage return to the device terminator.
TERM? NONE Returns the status of the TERM command.
TIME? NONE Returns the elapsed time since the instrument was last powered
up.
TIMER? NONE Returns the elapsed time since the timer was last reset.
*TST? Initiates an internal self−test and returns a response when
complete.
*WAI Prevents executing any further commands until the No−
Operation−Pending flag is true.
Table 4.1 GPIB Command Summary Reference List
Name Parameters Function
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com