ILX Lightwave LDC-3700B Series - Page 85

COMMAND REFERENCE
Command Reference
70 LDC-3700 Series
CHAPTER 4

The LASer:DISplay:PARAM command enables the LASer display to show the LASER parameter
values.
Parameters None.
Notes This command has the same effect as pressing the (PARAMETER) SELECT switch while in LASER
mode. The selected parameter will be displayed for three seconds. The actual LASER PARAM
display is turned off automatically when a LASER display selection is enabled.
Each time the command is issued, the next LASER parameter will be selected, see Chapter 2 for
more information.
Examples "Laser:Display:Param" −action: selects a LASER parameter and displays its value.
"LAS:DIS:PARAM" −action: selects a LASER parameter and displays a its value.
The LASer:DISplay:SET command sets the laser display to show the set point of the selected
LASER DISPLAY mode.
Parameters None.
Notes Using this command has the same effect as physically holding the (LASER DISPLAY) SET switch
down (in).
Examples "Las:Dis:Set" −action: enables the LASER display for the set point of the selected mode: LDI, MDI
(I
PD
) or MDP (P
PD
)
"LAS:Dis:Set" −action: enables the LASER display for the set point of the selected display mode.
The LASer:DISplay:SET? query returns the status of the (LASER DISPLAY) SET switch.
Notes The set point display will not time out when REMOTE operation is used. (It will be continuously
displayed.)
Examples "LAS:DISPLAY:SET?" −response: 0, means the measured value is enabled for the LASER display.
"Las:Dis:Set?" −response: 1, means the set point value is enabled for the LASER display.
LASer:DISplay:PARAM
COMMON
DEVICE DEPENDENT
FRONT PANEL
LASer:DISplay:SET
COMMON
DEVICE DEPENDENT
FRONT PANEL
LASer:DISplay:SET?
COMMON
DEVICE DEPENDENT
FRONT PANEL
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com