IMEON 3.6 - 4- Communication

IMEON 3.6
55
Manuel d’installation / Installation manual IMEON 3.6 – Rev A.2
FR
EN
Step
4:
Connect the RST connector on the
input GRID CONNECTION.
As the
following image shows it.
Step 5: Make sure the wires are safely connected.
CAUTION: To prevent risk of electric shock, ensure the ground wire is properly earthed before
operating this hybrid inverter whether the grid is connected or not.
Note: The current injection to the grid from the inverter cannot go over 16A (13A nominal).
4- Communication
The inverter is equipped with RS232 and USB ports and it is also equipped with a slot for alternative
communication interfaces in order to communicate with a PC with corresponding software. This
intelligent slot is suitable to install with Modbus or Ethernet card.