Immarsat FB500 - TST Config

8-5
8.1.2 TST Config
Set the parameters used for operation test.
NOTE
Reconfigure the parameters as follows, when you complete TEST CONFIG screen.
Setting of the parameters in this screen is remained in effective, although you reboot the
equipment.
Incorrect setting may cause malfunction.
(Follow the explanation (d) to set ADE Mode).
(a) PA ON/OFF
Fig. 8.1.2a PA Output setting
9 ADMIN
0 SERVICE
READY
1 Memory CLR
2 TST Config
READY
01 PA Output
02 Position
ＯＫ
ＯＫ
ON
OFF
Returns to previous
PA Out
p
ut settin
g