impro technologies HRB910 User Manual

www.impro.net Impro Biometric Reader – Installation Manual Page 4 of 25
Introduction
Document Purpose
Install and configure the Impro Biometric Reader with guided example steps:
 Adding the IBR to the Access Portal access control system
 Adding a tagholder (person)
 Adding fingerprint templates to a tagholder.
Intended audience
Personnel who perform the following:
 Mounting and wiring of the IBR Reader/Controllers and other system hardware
 Configure and maintain the Access Portal PACS.
Related products
Access Portal hardware
Plastic modules that plug together
 Wiegand Cluster (HCW91X)
• Provides a Cluster Controller and 1, 2 or 3 Wiegand Reader modules.
 Wiegand Reader Module, plastic expansion module (HMW900)
• Provides two x (Wiegand interface, relay, Door Position Sense, Request to Exit)
Integrated Power Supply (IPS) Combo
 IPS Boxed Solution (HCW93X)
• Provides a Cluster Controller and 1, 2 or 3 Wiegand modules in an Integrated Power Supply housing.
 Wiegand Reader Module, IPS expansion module (HMW901)
• Provides two x (Wiegand interface, relay, Door Position Sense, Request to Exit)
Related material
Refer to the documents and links listed in the following table for information related to the content of this guide:
Refer to this document
For
Impro Biometric Reader Quick Start Guide
(PLT-04644 – included with the IBR)
Basic installation information
Visit this URL
For
https://www.impro.net/software/
Access control software options ranging from free and basic up to Enterprise

impro technologies HRB910 Specifications

General

Brand	impro technologies
Model	HRB910
Category	IP Access Controllers
Language	English