99903514:TELESCOPIC CRANE: 5-3
SECTION 5: DECALS
5-2. “DANGER” DECAL DESCRIPTIONS
All operators must familiarize themselves with the “DANGER” decals shown in this section. Your equipment may have
additional safety decals that are not described here. Any safety decals affixed to your equipment must be identified, read
and understood.
The materials and adhesives used in the production of these decals were designed for maximum durability, adhesion and
legibility. Nevertheless, if a decal (including capacity chart) becomes damaged or illegible, replace it at your earliest
opportunity. If a crane is repaired or repainted, replace all decals before the crane is put back into service. Individual decals
as well as complete decal kits are available from IMT.
The following figures show the safety decals used on IMT cranes. They are illustrated here as an aid in their identification
with an explanation of their purpose, where they are placed on the crane and the normal quantity used on each crane.
Figure E-2
DECAL: Crane Operation Hazards
PART NUMBER: 70396613
FUNCTION: To inform the operator of the
hazards associated with untrained
operation, contact or proximity to
electrical lines, crane two-blocking, and
lifting personnel. The decal defines the
possible consequences should the
hazard occur and how to avoid the
hazard.
WHERE USED: Telescoping Cranes
PLACEMENT: At or near the remote
control handle storage point.
QUANTITY: 1
20120104
Follow Safe Operating & Inspection Procedures
Electrocution Hazard
Crane and remote control are not insulated.
70396613
Falling Load Hazard
Death or serious injury will result from approaching or contacting a power line.
Falling loads may injure or kill.
Fall Hazard
Riding on boom, hook, or loadline may injure or kill.
Overload Hazard
Overloading the crane may injure or kill.
WARNING
To Next Page
Loading...
Need help?
General
