Inateck BCST-55 - Reveal Battery Status; Data Transmission Speed

5
How to Set up the Scanner
You may change the settings of BCST-55 barcode scanner by reading the setting barcode in
this manual. The examples of settings for the BCST-55 scanner are as below.
Note: If there is a (*) before a certain setting barcode in this manual, it indicates the factory
preset.
Steps
Operation
1
Toggle the switch to "ON" and short press the scan button to power on the
scanner.
2
Scan the barcode to enter setup mode.
Enter Setup
3
Read the setting barcode, such as:
Enable Codabar
4
Read the barcode to exit setup
mode.
Exit and Save
To clear a wrongly scanned setting
barcode, read the barcode below.
Exit without Save