Inateck BCST-55 - Delete Characters on Output Result

Enter Setup
Exit and Save
43
Delete Characters on Output Result
When outputting scanning result, the BCST-55 supports deleting 0–99 digit(s) front
characters and 0–99 digit(s) end characters from a barcode.
Steps to set deleting front 12-digit characters and end 4-digit characters are as below:
1. Read the "Enter Setup" barcode.
2. Read the "Set the Number of Front Digit(s) to be Deleted" barcode.
3. Scan the "1 Digit" barcode.
4. Scan the "2 Digits" barcode.
5. Scan the "Set the Number of End Digit(s) to be Deleted".
6. Scan the "4 Digits" barcode.
7. Scan the "Exit and Save" barcode.
Set Number of Front Digit(s) to be Deleted
Set Number of End Digit(s) to be Deleted
(*) 0 Digit
1 Digit
2 Digits
3 Digits
4 Digits
5 Digits
6 Digits
7 Digits