Inateck BCST-55 - Replace GS (^]) with Specific Character

Enter Setup
Exit and Save
50
Replace GS (^]) with Specific Character
The BCST-55 supports replacing the GS separation character (^]) with specific characters.
The scanner defaults disabling the function.
Steps to set replacing GS separation character with character "A" are as below:
1. Read the "Enter Setup" barcode.
2. Read the "Set the GS Replacement Character" barcode.
3. Read the "A" barcode in Appendix I.
4. Read the "Exit and Save" barcode.
Note: After you complete setting the replacement character by following steps above, the
BCST-55 will automatically enable the replacing GS with other characters function. If you
want to disable the function, please read the "Enter Setup" - "Disable Replacing GS with
Other Character" - "Exit and Save" barcodes in turn.
Set the Replacement Character
Enable Replacing GS with Other Characters
(*) Disable Replacing GS with Other Characters