Inateck BCST-55 - Specific Initial Character Reading

Enter Setup
Exit and Save
42
Custom Code Prefix/Suffix Setting
The BCST-55 supports customizing 1-32 digit(s) of barcode prefix, and 1-32 digit(s) of
barcode suffix. The prefix and suffix can be either shown or hidden. The scanner defaults
showing the prefix and suffix. Please refer to the Appendix for the supported prefix/suffix
characters.
Steps to set the prefix as "#" and the suffix as "D" are as below:
1. Read the "Enter Setup" barcode.
2. Read the "Set Prefix" barcode.
3. Read the "#" barcode in Appendix I.
4. Read the "Set Suffix" barcode.
5. Read the "D" barcode in Appendix I.
6. Read the "Exit and Save" barcode.
Note: After you successfully set prefix and suffix, the BCST-55 will by default output
scanning result with prefix and suffix.
Set prefix
(*)Show prefix
(*)Show suffix
Set suffix
Hide prefix
Hide suffix