INFANT
WITH INBUILT HARNESS
SELECTION OF APPROPRIATE PADDING COMBINATIONS
Determine whether your infant /child requires the additional padding provided with this restraint,
to ensure a safe and snug t in the restraint. Refer to page 6 for suggested padding combinations.
- Refer to the shoulder height labels
(As shown on pages 9).
- For correct shoulder strap slot
height refer to page 12.
IMPORTANT
!
CONVERTING TO INFANT SEAT
At the front of the restraint is a red
lever. Pull red lever forward and recline
the seat base as far as possible.
Ensure the recline section is swung
forward (see Figure 1).
Ensure the In-built harness “Shoulder
straps” are positioned in the lower
slots.
Figure 1
REAR
FRONT
RED
LEVER
RECLINE
SECTION
Front
of Car
To ensure baby’s back is evenly supported, do not put more than one nappy on the baby and
make
sure the nappy is not thickly folded at the back.
WARNING
!
RECLINED POSITION
11
To Next Page
Loading...
