INFANT
WITH INBUILT HARNESS
INSTALLATION
Place the child restraint on the vehicle seat. Ensure
recline section is swung forward and the restraint is
fully reclined with the restraint directly in line with
anchorage point.
Make sure upper anchorage strap is as in illustration
(Figures 1 and 2) i.e. positioned around restraint
back.
Feed adult lap or lap/sash belt through the belt path
opening, ensure the seat belt is under the cover &
between the layer of foam and the plastic seat base.
Engage the buckle and tongue assembly (listen for a
“CLICK”). Check the buckle engagement with a
gentle pull.
Step 1:
Step 2:
Step 3:
INSTALLING IN VEHICLE
DO NOT USE REAR FACING CHILD RESTRAINT WHERE AN AIRBAG IS FITTED IN
FRONT OF THE SEATING POSITION.
Fit the restraint rmly to the car seat.
THIS TETHER STRAP MUST ALWAYS BE FITTED WHEN THE CHILD RESTRAINT IS
USED IN A VEHICLE.
Figure 2
WARNING
!
Buckle & Tongue
Assembly
Figure 1
Upper
Anchorage
Strap
Safe Grip
(red belt clamp)
Adjuster
Lap Belt
& Sash Belt
Front
of Car
Recline Section
Recline Section (Swung Forward)
& child restraint fully reclined.
Lap Belt &
Sash Belt Passes
Through Here
IMPORTANT
!
Ensure that you use the REARWARD-FACING
BELT PATH indicators, marked in “blue”.
14
To Next Page
Loading...
