Infasecure CS4010 - Page 36

ACCESSORIES
SUN HOOD (if tted)
The Sun Hood (if tted) is designed to provide
additional sun shade.
Attach the sun hood using the press studs.
Step 1:
SEAT PROTECTOR
FULL LENGTH
(if tted)
The seat protector is designed to protect
your car’s seat.
STANDARD
Position the front ap with pockets, at the
front of the rear seat and position the mat
rearwards to obtain a at t.
FULL LENGTH
Position the front ap with pockets, at the
front of the rear seat and position the mat
rearwards to obtain a at t. (If required an
additional ap has been provided to tuck in
between the seat back & cushion)
Position the back section up the seat back
and use the plastic buckle & webbing strap
to attach around the vehicle seat headrest
(if the rear vehicle seat does not have a
headrest then the strap could be used to
attach around the child seats top tether
after you have installed the child seat).
Step 1:
Step 1:
Step 2:
STANDARD
“PRESS”
“PRESS”
“PRESS”
34