Figure 12 Rebuild All
• Download the application using the IAR I-JET debugger
Note: If you do not have the IAR I-jet Debugger, then skip Steps 6 to 8.
6. Connect the IAR I-jet Debugger to either J3 (MIPI 20-pin) or J5 (MIPI 10-pin) of the CYHVPA-128K-32-001
Evaluation Board with power supply (See Figure 13). See the PSoC
™
HV PA Evaluation Board user guide
(References) for more detailed information.
Getting started with PSoC
™
HV PA family
3 Development environment and tools
Application note 23 002-30264 Rev. *B
2023-04-19
To Next Page
Loading...
