User Guide 21 of 25 002-32910 Rev. *A
2021-09-29
Getting started with TRAVEO™ T2G entry family starter kit
Download and debug with starter kit
6. Place a break point in the SystemInit()API in the CM4 core workspace. CM4 core will start executing after
being enabled by CM0+ core. You can debug both cores simultaneously.
Note: To place a breakpoint at the target instruction, click the white space between the editor window
(left pane) and the workspace window (center pane).
Figure 27 Dual core Debug windows
7. Now, click the Go icon in the CM0+ workspace to start execution. After executing
Cy_SysEnableApplCore(), CM4 core will be enabled and the execution will reach the breakpoint in the
CM4 workspace. You can now continue to debug the code from CM4 core.
To Next Page
Loading...
