InFocus IN116a User Manual

20
Using the audio
Using the projector’s speakers
Connect the audio source to the Audio 1/Audio 2 connectors to hear audio
through the projector speakers.
Amplified speakers may also be connected to the projector using the Audio Out
connector.
To adjust the volume, press the Vo
lume buttons on the remote.
Troubleshooting Audio
If you aren’t hearing the audio, check the following:
• Make sure the audio cable is connected to the Audio 1/
Audio 2 connector on
the projector, and that the other end of the cable is connected to an Audio
Out connector on the source (not a “line-in” or “microphone” connector).
• Make sure the volume is turned up enough. Press the Vo
lume button on the
remote.
• Make sure the correct source is active.
• Adjust the audio source.
• If playing a video, make sure the playback has not been paused.
connect audio cable

InFocus IN116a Specifications

General

White Brightness	3000 lumens
Native Resolution	1280 x 800
Contrast Ratio	15, 000:1
Aspect Ratio	16:10
Throw Ratio Range	1.5 to 1.8
3D	yes
Video Input	vga, hdmi, s-video, composite video
Inputs	hdmi, composite video, s-video, usb, vga
OS Compatibility	mac, windows

Weight and Dimensions

Depth	8.7 inches
Height	4.3 inches
Width	11.5 inches
Net Weight	5.4 pounds