InFocus INL4128 - Page 31

English
31
USING THE PROJECTOR
Note:
• These options are only available if the 3D mode function is disabled, the Wall Color setting is not set
to Blackboard, and the Display Mode setting is not set to DICOM SIM. or HDR SIM..
• In 3D mode, user can only select 3D for Gamma setting.
• If the Wall Color setting is set to Blackboard, user can only select Blackboard for Gamma setting.
• If the Display Mode setting is set to DICOM SIM., user can only select DICOM SIM. for Gamma
setting.
• If the Display Mode setting is set to HDR SIM., user can only select HDR SIM. for Gamma setting.
Color Settings
Congure the color settings.
• BrilliantColor
TM
: This function utilizes a new color-processing algorithm and enhancements to enable
higher brightness while providing true, more vibrant colors.
• Color Temperature: Select a color temperature from Warm, Standard, Cool, or Cold.
• Color Matching: Select the following options:
– Color: Select the color to adjust: red, green, blue, cyan, yellow, magenta, or white.
– Hue / R(red)*: Adjust the hue (color) of the color selected in the Color setting.
Note: *If the selected color is White, you will adjust the red level.
– Saturation / G(green)*: Adjust the saturation (o󰀨set) of the color selected in the Color setting.
Note: *If the selected color is White you will adjust the green level.
– Gain / B(blue)*: Adjust the gain (level) of the color selected in the Color setting.
Note: *If the selected color is White you will adjust the blue level.
– Reset: Return the factory default settings for color matching.
– Exit: Exit the “Color Matching” menu.
• RGB Gain/Bias: This function adjusts the gain and bias of individual colors.
– Reset: Return the factory default settings for RGB gain/bias.
– Exit: Exit the “RGB Gain/Bias” menu.
• Color Space (non-HDMI input only): Select an appropriate color matrix type from the following:
AUTO, RGB, or YUV.
• Color Space (HDMI input only): select an appropriate color matrix type from the following: Auto, RGB
(0-255), RGB (16-235), and YUV.
Signal
Adjust the signal synchronization settings for VGA/Component sources.
• Automatic: Congure automatically the signal (the frequency and phase items are grayed out). If
automatic is disabled, the frequency and phase items will appear for tuning and saving the settings.
• Frequency: Change the display data frequency to match the frequency of your computer’s graphic
card. Use this function only if the image appears to icker vertically.
• Phase: Synchronize the signal timing of the display with the graphic card. If the image appears to be
unstable or ickers, use this function to correct it.
• H. Position: Adjust the horizontal position of the image.
• V. Position: Adjust the vertical position of the image.