English
32
USING THE PROJECTOR
Brightness Mode
Adjust the brightness mode settings.
• DynamicBlack: Automatically adjusts the brightness based on the source signal for optimum contrast
performance.
• Power: Select the power percentage to adjust the overall brightness.
Reset
Return the factory default settings for color settings.
Display 3D menu
Note:
• This projector is a 3D ready projector with DLP-Link 3D solution.
• Please make sure your 3D glasses are use for DLP-Link 3D before enjoy your video.
• Supports Frame Sequential (page ip), Side-by-Side (SDS) and Top Bottom 3D video formats.
• To enable 3D mode, the input frame rate should be set to 60Hz only, lower or higher frame rate is not
supported.
• To reach the best performance, resolution 1920x1080 is recommended, please be noted that 4K
(3840x2160) resolution is not supported in 3D mode.
• 3D from a Blu-Ray 3D is detected and displayed automatically.
3D Mode
Use this option to disable the 3D function or select the appropriate the 3D function.
• O: Select “O” to turn o 3D mode.
• DLP-Link: Select to use optimized settings for DLP 3D Glasses.
Note: If 2D and 3D sources are both connected, turn o 3D when selecting the 2D source.
3D → 2D
Use this option to specify how the 3D content should appear on the screen.
• 3D: Display 3D signal.
• L (Left): Display the left frame of 3D content.
• R (Right): Display the right frame of 3D content.
3D Format
Use this option to select the appropriate 3D format content.
• Auto: When a 3D identication signal is detected, the 3D format is selected automatically.
• SBS: Display 3D signal in “Side-by-Side” format.
• Top and Bottom: Display 3D signal in “Top and Bottom” format.
• Frame Sequential: Display 3D signal in “Frame Sequential” format.
3D Sync Invert
Select whether the right or left eye of the glasses synchronizes rst.
To Next Page
Loading...
