InFocus P111 - Advanced 1 Features (Settings 2); Advanced 1 Settings (Settings 2)

IN3144_IN3146_IN3148HD User’s Manual
— 34 —
Advanced 1 Features
Press the Menu button to open the OSD menu. Press the ◄► buttons to move to the Settings 2
menu. Press the ▲▼ buttons to move to the Advanced 1 menu and then press (Enter) or ►.
Press the ▲▼ buttons to move up and down in the Advanced 1 menu. Press the ◄► buttons to
enter and change setting values.
ITEM DESCRIPTION
Menu Position Press the ◄► buttons to enter and select different OSD location.
Translucent Menu Press the ◄► buttons to enter and select OSD background translucent level.
Low Power Mode Press the ◄► buttons to enter and turn Low Power Mode Off, Low Power, Network.
Fan Speed
Press the ◄► buttons to enter and toggle between Normal and High fan speeds.
Note: We recommend selecting high speed in high temperatures, high humidity, or
high altitude (higher than 1500m/4921ft) areas.
Lamp Hour Reset
After replacing the lamp, the lamp should be reset. See page 35 for more information
on Lamp Hour Reset.
Projector ID
Press the ◄► buttons to enter and adjust the two digit projector ID from 00 through
98.
Network
Press (Enter) or ► to enter the Network menu. See page 35 for more information
on Network.
Note:
When "Network" is enabled, VGA Out is inactive when the projector is in standby mode.
Both VGA OUT and Network control are active in standby when Low Power Mode is set to Off.