InFocus P111 - Error Indicators and Diagnosis; LED Error Messages

IN3144_IN3146_IN3148HD User’s Manual
— 52 —
LED Error Messages
ERROR CODE MESSAGES
POWER LED
GREEN
LAMP LED
RED
TEMP LED
RED
Lamp Ready ON OFF OFF
Start Flashing OFF OFF
Cooling Flashing OFF OFF
Over Temperature T1 OFF 1 blinks ON
Thermal Break Sensor error 4 blinks OFF OFF
G794 error 4 blinks 1 blinks OFF
Lamp Re-Strike 6 times Failed 5 blinks OFF OFF
Lamp Temperature shut down(Ballast Temp) 5 blinks 1 blinks OFF
Lamp Short circuit in
output detected(Ballast
circuit short)
5 blinks 2 blinks OFF
Lamp End of lamp life detected 5 blinks 3 blinks OFF
Lamp did not ignite 5 blinks 4 blinks OFF
Lamp extinguished during normal operation 5 blinks 5 blinks OFF
Lamp extinguished during run-up phase 5 blinks 6 blinks OFF
Lamp voltage too low 5 blinks 7 blinks OFF
Lamp Ballast Fail 5 blinks 8 blinks OFF
Lamp Ballast COMM Fail 5 blinks 10 blinks OFF
Lamp Ballast Over Temp 5 blinks 11 blinks OFF
Lamp voltage too low 5 blinks 12 blinks OFF
FAN1 error 6 blinks 1 blinks OFF
FAN2 error 6 blinks 2 blinks OFF
FAN3 error 6 blinks 3 blinks OFF
FAN4 error 6 blinks 4 blinks OFF
1W MCU detects scaler stops working 2 blinks OFF OFF
Case Open 7 blinks OFF OFF
DMD error 8 blinks OFF OFF
Color wheel error 9 blinks OFF OFF
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting
the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart
above
, please contact InFocus Support.