EonNAS Pro Series Hardware Manual
3. USB
ports
The USB ports are for external expansion purposes (CD,
DVD, USB flash drives, printers, etc.); or to supply power to
external eSATA devices.
4. Ethernet port 1 Ethernet port 1 is used for accessing and configuration.
5. Ethernet port 2 Ethernet port 2 is used for accessing and configuration.
6.
Restore default
button
The restore default button is for restoring the system to
manufacturing settings (TCP / IP, system settings, etc.),
please refer to Restore Default Settings
. The button is NOT
operational during initialization.
7. VGA port Reserved.
8.
Kensington
lock-hole
For use with a Kensington lock. Please refer to your
Kensington lock for instructions.
9.
Power adaptor
For plugging in the power adaptor.
10.
Expansion host
port location
For selected models only, expansion host port features four
1Gb iSCSI host ports or two 10Gb iSCSI host ports.
11. Serial COM port The serial COM port is reserved for maintenance purposes.
12.
ATX power
switch
The ATX power switch acts as a secondary power switch
and it must be switched to the “ON” position to power-on
the system.
13. USB 3.0 port
The USB 3.0 port differs to other USB ports in that it
supports a maximum 5Gb/s transfer rate.
Additional 1Gb iSCSI Expansion Ports
For selected models that has four additional 1Gb iSCSI host ports. From left to right
are CH3, CH4, CH5 and CH6 1Gb iSCSI host ports.
CH3 CH4 CH5 CH6
15
To Next Page
Loading...
