EonNAS Pro Series Hardware Manual
Powering-on the System & Initialization
WARNING
Hard drive data will be erased!
NOTE
Turn off Windows firewall:
To turn off the Windows firewall, please refer to the instructions below.
Windows 7/ Vista:
Click on the Start button > Control Panel > Security > Windows Firewall >
turn off Firewall. You may be prompted for an administrator password or
confirmation, type the password or provide confirmation.
Windows XP:
Click on the Start button > Control Panel > Windows Firewall > turn off
Firewall.
1. Approximately 5 minutes after pressing the power button (if the user is near
the system, after pressing the power button, a beep will sound after 2 minutes
and two beeps will sound 3 minutes thereafter) double click on
Na F
found in the “fscommand" folder on the CD. A NasFinder window will appear.
s inder.exe
2.
Select your preferred interface language.
3. Highlight your system and click the “Connect” button.
Discovered Device List
Name Model IP Address
NAS_500
NAS-500 10.0.0.2
NOTE
If your NAS system was not found
• Make sure your PC and NAS are connected to the same switch / router!
• Try turning off the antivirus’ firewall (please refer to its manual) then close the
NasFinder and go back and start from step 3.
• Please refer to the setup instructions in the User Manual on the CD.
31
To Next Page
Loading...
