EonNAS Pro Series Hardware Manual
Restore Default Settings
Under the following circumstances, you may need to restore to system default
settings:
You forgot your password and you are unable to access the NAS server
Note:
Restoring the system to its default settings should be your last option. The restore
default function will disable Jumbo Frame, reset port trunking settings and reset the
“Admin” user account back to default (account: admin / password: admin).
The restored “settings” will search the network in DHCP mode for 3 minutes and if
unsuccessful in acquiring an IP address, it will revert to the default IP address of
10.0.0.2 for Ethernet port 1 and 10.0.0.3 for Ethernet port 2; default username: admin,
default password: admin.
To restore default settings:
1. Stop all system I/Os.
2. Use the tip of a pen to press and hold the restore default button for 3 ~ 5 seconds
and release, a beep will sound to indicate that default settings have been restored.
eS ATA
1
2
RS 232/485
200 / 500 / 800 210 / 510 / 810 850
61
To Next Page
Loading...
